Instruction manual

-19--18-
CAMERA ADJUSTMENT CAMERA ADJUSTMENT
BOTTOM: Set the bottom side of the monitoring frame selected by the AREA
SEL parameter
LEFT: Set the left side of the monitoring frame selected by the AREA SEL
parameter.
RIGHT: Sets the right side of the monitoring frame selected by the AREA SEL
parameter
CAMERA ID OFF / ON
Camera ID shows a name on the screen as chosen.
CAMERA ID
CAMERA
ABCDEFGHIJKLMNOPQRSTUV
WXYZ0123456789-!#$%&’
()_`.:;<=> @^*./^*X+/
CHR1 CHR2
 CLR POS
RETURN

Use Up/Down/Left/Right to move around. CHR1/2 changes the selection fonts to
alternative selection, CLR will clear info. POS allows position change.
MOTION DET OFF / ON
Motion Detection is dened by rectangular areas. This give a visual identication
of motion areas.
MOTION DET
DETECT SENSE
111
BLOCK DISP OFF
MOTION AREA ON
AREA SEL 1 / 4
TOP
000
BOTTOM
000
LEFT
000
RIGHT
000
RETURN

DETECT SENSE: Sets the motion detection sensitivity
BLOCK DISP: ON/OFF/ENABLE status of the motion detection
block display.
ON: Make motion areas visible, OFF: Hide motion areas
ENABLE Press enter to access the “dead band setting”
screen, on-screen cursor moves in response to the
inputs Left, Right, Up and Down to set the sensing area,
or dead band for specied blocks. This allows you to
specify and set an area of motion which is not
rectangular in shape.
Press and hold SET button 3 seconds to exit.
MOTION AREA: ON / OFF Enable / Disable Area No.
AREA SEL: 1/4 / 2/4 / 3/4 / 4/4. Selects motion area number.
TOP: Set the top side of the monitoring frame selected by the AREA SEL
parameter.