Instruction manual

FLIR SyncroIP NVR CMS Central Management Software
15
2. Click Monitor Project.
3. Click New.
4. Enter a Name for the project.
CAUTION
You may not change the name after the project is created.
5. Under Mode, select Tour Mode or Schedule Mode. Tour Mode will cycle through
tasks on a fixed interval. Schedule Mode will switch tasks at a pre-defined time of the
day.
6. Under Task Name, select the task you would like to add to the project.
• If you select Tour Mode, enter the Interval Time in minutes that the task will run for
before changing to the next task.
• If you select Schedule Mode, enter the time of day when the task will start running.
7. Click Add.
8. Repeat steps 6-7 for each additional task you would like to add to the project.
9. Click OK. Click OK to save changes.
#; r. 1.0/11603/11605; en-US
65