Instruction manual

Using the Main Menu14

To configure display settings:

1. Configure the following, as needed:

• Transparency: Select the menu transparency between 128 (lowest) and 255

(highest).

• Channel Name: Click Modify and enter names for your IP cameras. Click Save

when finished.

• Time Display: Check to enable system time display.

• Channel Display: Check to enable camera title display.

• Resolution: Select the correct resolution for your monitor. The system will reboot

when you save changes.

• Image Enhance: Check for the system to digitally improve the video quality on the

live display. This setting does not affect recordings.

• Enable Sequence: Check to enable Sequence mode. When Sequence mode is

activated, the system will cycle through enabled views and a (arrows) icon is shown

on screen. You can click this icon to pause Sequence mode.

• View 1/View 4/View 8: Check to enable views to be shown in Sequence mode.

View 1 allows you to enable/disable specific channels in Sequence mode. Other

View options allow you to enable/disable views based on pages. On 8-channel

models for example, View 4 #1 represents channels 1~4 and #2 represents chan-

nels 4~8.

Note

Available options depend on the number of channels your system has.

• Dwell: Enter the Dwell time in seconds. The Dwell time is the amount of time views

are shown on screen before changing in Sequence mode.

• Motion Sequence Type: Select the view type that will be viewed when motion is

detected.

2. Click Save to save changes.

14.2.17 Default

The Default sub-menu allows you to reset the system to factory default settings.

Note

Resetting to factory defaults does not reset user accounts or passwords.

To reset the system to factory default settings:

1. Check the menus you would like to reset to default settings.

2. Click OK.

#; r. 1.0/11603/11605; en-US