Instruction manual

Using the Main Menu14

5. Under Sensitivity, select the motion detection sensitivity between 1 (lowest) and 6

(highest).

6. Under Anti-dither, enter the anti-dither time. After a motion event occurs and motion

stops, if motion is detected within the anti-dither time, the system continues the motion

event and includes the new motion within the first event, rather than creating a new

motion event.

7. Under Delay, enter the post-recording time.

8. To configure a schedule when motion detection will be enabled on this channel, click

Set next to Period. Configure times when motion detection will be enabled. For exam-

ple, you may want to disable motion detection during business hours and enable it out-

side of business hours. Click OK when finished.

Note

This setting can override scheduled motion recording. This means that motion recording will only

take place at times that are enabled both in the Schedule menu and here.

9. Configure the following system actions when motion is detected:

• Show Message: Check to enable an on-screen pop-up. On-screen pop-up shows

the channels an event occurred on and the type of event.

• Send Email: Check to enable email alerts. You must configure email alerts before

you will be able to receive them (see 14.2.12 Configuring Email Alerts, page 36).

• Record Channel: Select the channels that will record when motion is detected on

the selected channel.

• Buzzer: Check to enable the system buzzer.

• Snapshot: Check to attach a .jpg image of the camera when sending email alerts.

10. Click Save to save changes.

14.2.16 Display

The Display sub-menu allows you to configure the system’s display settings, such as the

monitor resolution.

#; r. 1.0/11603/11605; en-US