Instruction manual

Using the Main Menu14

14.2 Setting

The Setting menu allows you to configure general system, schedule, network, recording,

display, and motion settings. It also allows you to restore the system to factory defaults.

14.2.1 General

The General sub-menu allows you to configure the time and general system settings.

The General sub-menu contains the following options:

• System Time: Select the current date and time and click Save to save changes.

• Date Format: Select the date format (YYYY MM DD, MM DD YYYY, or DD MM YYYY).

• Date Separator: Select if you would like a dot (.), dash (-), or slash (/) to separate the

date display.

• DST: Check to enable daylight savings time adjustments. To configure the start and

end times for daylight savings, click Set. Then, configure the Start and End as needed,

and click OK.

• Time Format: Select 24-HOUR or 12-HOUR.

• Language: Select the system language.

• Video Standard: Select NTSC (North America) or PAL (Europe).

• Device No.: Select the remote control ID for the system.

• Device ID: Enter a custom name for the system.

• HDD Full: Select Overwrite for the system to begin overwriting the oldest recordings

when the hard drive is full or select Stop Recording for the system to stop recording

when the hard drive is full.

• Pack Duration: Enter the desired pack duration. The pack duration determines the du-

ration of video files saved to the system.

• Realtime Play: Select the duration of videos that will be played back in Quick Playback

mode. For example, if Realtime Play is set to 5 minutes, Quick Playback will start play-

ing back video recorded from 5 minutes ago on the selected channel.

• Mouse Property: Click MouseSet, adjust the double-click speed and click OK.

• Startup Wizard: Check to enable the Startup Wizard when your system starts. It is rec-

ommended to disable Startup Wizard once you have configured the system.

• Navigation: Check to enable the System Toolbar that appears when left clicking on the

screen.

• Auto Logout: Enter the amount of time the system will wait before logging a user out

when idle.

• IPC Time Sync: The system will regularly sync the internal clocks of connected IP cam-

eras. Enter the interval between time syncs.

#; r. 1.0/11603/11605; en-US