Instruction manual

DNR300 Series Hard Drive Installation

5. Turn the unit over and tighten the hard drive screws.

6. Turn the unit back over and connect the SATA power and data cables to the hard drive.

7. Replace the cover and cover screws. Make sure to slide the lip on the cover under the

bottom of the front panel.

Note

After installation, you must format the hard drive in order to use it with the system. See 22.3 Format-

ting Hard Drives, page 119.

22.2 Removing the Hard Drive

CAUTION

Make sure that the system is OFF and ALL power adapters have been disconnected before removing/in-

stalling the hard drive.

1. Power off the system, and unplug all cabling from the system.

2. Remove the screws (4x) from the back panel. Slide the cover back and up to remove.

#; r. 1.0/11603/11605; en-US

118