Instruction manual

Setting up Remote Viewing

Setting up the Remote Viewing Feature requires several steps. Networking skills are re-

quired to correctly configure the remote viewing functions.

18.1 What Do I Need?

• NVR System.

• A PC with the installed CMS software.

Note

For Mac users, please visit www.flirsecurity.com/pro for instructions.

• A router (not provided with the system) and High Speed Cable or DSL Internet Connec-

tivity (for remote viewing outside your network).

18.2 Network Setup / Remote Access Overview

To setup remote viewing:

1. With the system powered off, connect the system to the router using an Ethernet cable.

2. Power the system on.

3. Press the Enter button on the remote control or front panel to find your system's IP

address.

4. Enable Port Forwarding on your router for the Client (default: 35000) and HTTP Ports

(default: 80). To set up port forwarding, use the included Auto Port Forwarding Wizard

software (19 Auto Port Forwarding Wizard, page 104) or refer to your router manufac-

turer’s instruction

5. Setup an account at http://ddns.myddns-flir.com. For details, 20 Setting Up DDNS

Service, page 111.

18.3 Finding your IP Address and MAC Address

The IP and MAC address of your system are necessary for DDNS setup. DDNS allows

you to view and control your system from a remote location.

To find your IP and MAC address:

• Press Enter on the remote control or front panel.

• Left-click to open the Navigation Bar. Login if prompted. Click

to open the System

Info screen.

#; r. 1.0/11603/11605; en-US

102