Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting

86
Appendix A: System Specifications
APPENDIX A: SYSTEM SPECIFICATIONS
System
Inputs/Outputs
Display
Recording
Main Processor Dual-core embedded processor
Operating System Embedded LINUX
Pentaplex Operation Simultaneous View, Record, Playback, Backup, and Remote Monitoring
IP Camera Input 8 channel / 16 channel
Power over Ethernet
(PoE)
8 integrated PoE ports
Audio 1 channel input (BNC), 1 channel output (BNC)
PTZ RS-485, supports Pelco-D and Pelco-P
USB 2 ports
Alarm Input 8 Channel
Relay Out 3 Channel
Interface 1 HDMI, 1 VGA, 1 BNC
Resolution 1920×1080, 1280×1024, 1280×720, 1024×768
Display Split 1/4/8/9, 1/4/8/9/16
OSD Camera Title, Time, Camera Lock, Motion Detection, Recording Status
Compression H.264
Resolution 1080P (1920×1080) / 720P (1280×720)
Record Rate 240FPS @ 1080P / 480FPS @ 720P
Bit Rate 160Mbps
Record Mode High Quality Stream/Sub-Stream Recording: Manual, Schedule, Motion Detection,
Alarm
Record Interval 1~120 min (default: 60 min), Pre-record: 1~30 sec, Post-record: 10~300 sec