Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
84
Mobile Connectivity
4. Tap MotionDetect then check each channel you would like to receive push notifications from.
Check each channel you would
like to receive push notifications
from
5. Tap OK. A test notification will be sent to your device. After this, whenever the selected
cameras detect motion, you will receive a notification.
NOTE: Y
ou can see a list of notifications through the Ev
ent List menu. To show the Event List
menu, from live view, tap
then .
Tap on an event to view live
video from the camera
Device Manager
Device Manager allows you to manage your NVR’s.
To access Device Manager:
1. From live view, tap
then .
2. Tap Device Manager.
To
delete an NVR:
1. Tap the NVR to select it.