Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
76
Mobile Connectivity
Viewing Snapshots and Videos with Local Files
If you have saved snapshots or videos using FLIR SyncroIP NVR, you may open them with Local
Files.
To access Local Files:
• From the Main Menu, tap Local Fil
es.
Using Playback Mode on Android Phones
You can access recorded video on your NVR using your Android phone.
NOTE: Y
ou must enable Extra Stream Recording to use playback mode on mobile devices. For
details on enabling Extra Stream Recording, see “Recording” on page 24.
To use Playback Mode:
1. From the Main Menu, tap Playback.
2. If Playback is not shown, tap Add, check Playback, and r
eturn to the Main Menu.
Tap files to open
Open snapshots
Open videos
Delete all files
Return to Main Menu