Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
75
Mobile Connectivity
10. Tap + on one of the display areas and select the camera you would like to open in the selected
display area.
Tap + and select a camera
11. Repeat to view additional cameras.
FLIR SyncroIP NVR Interface
You can use FLIR SyncroIP NVR in portrait and landscape mode.
Double-tap to open a
channel in full-screen
Connect to camera
Disconnect from camera
Connect to all previously added
cameras
PTZ
Disconnect all
Access Favorites
Change Camera
Snapshot
Start/stop manual
record
Open image settings
Return to Main Menu