Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
71
Mobile Connectivity
Using Playback Mode on iPad
You can access recorded video on your NVR using your iPad.
NOTE: You must enable Substream Recording to use playback mode on mobile devices. For
det
ails on enabling Substream Recording, see “Recording” on page 24.
To use Playback Mode:
1. From Live View tap
then .
2. In Portrait Mode: Ta
p +, select the start time and end time for your search, and select the
camera you would like to playback.
OR
In Landscape Mode: Select th
e start time and end time for your search, and select the
camera you would like to playback.
Select start time
Select end time
Select camera
3. Use the playback controls.
Pause/play
Previous file
Next file
NOTE: Playback controls are only shown in portrait mode.