Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
68
Mobile Connectivity
iPad
FLIR SyncroIP NVR HD is an iPad app that allows you to remotely view your NVR.
System Requirements
• iOS 4.3 or later.
Prerequisites
• Port 80 and 35000 (or your HTTP and Client Ports, if you have changed them) must be port
forwarded on your router to your NVR’s IP address.
• You must create a DDNS account, and have the DDNS settings configured in your NVR.
• The NVR must have internet access.
• You must have a
DDNS
address to log in remotely.
NOTE: You will need to create an iTunes account before you can download the app. An iTunes
s
tore account requires a valid credit card number. The app is free of charge.
Connecting to your NVR on an iPad
1. Install FLIR SyncroIP NVR HD for free from the App Store.
2. Tap on the FLIR Syncro
IP NVR HD icon ( ) to start the app.
3. Tap
then .
4. Tap Device Manager.
5.
Tap Add.
Tap Add