Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
64
Mobile Connectivity
FLIR SyncroIP NVR Interface
You can use FLIR SyncroIP NVR in portrait and landscape mode.
Double-tap to open a
channel in full-screen
Connect to camera
Disconnect from camera
Connect to all previously added
cameras
PTZ
Disconnect all
Access Favorites
Change Camera
Snapshot
Start/stop manual
record
Open image settings
Return to Main Menu
Viewing Videos with Local File
If you have saved videos using FLIR SyncroIP NVR, you may open them with Local File.
NOTE: You may open screenshots using the Photos app.
To access Local
File:
• From the Main Menu, tap Local File.
Tap files to open
Delete all files
Return to Main Menu