Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
49
FLIR SyncroIP NVR Central Management Software
• Device: Click and drag the camera from the Device List in the main CMS window to the field
to add it.
• Stream Type: Select Main Stream or Extra Stream to view the substream.
7. Click Add. Repeat Steps 6 & 7 to configure additional screens.
8. Click OK. Clic
k OK to save changes.
Configuring Projects
Once you have multiple tasks set up, you can configure projects to automatically cycle through
them.
To configure a project:
1. Click Config Manager>Scheme Ta
sk Config.
2. Click Moni
tor Project.
Click Monitor Project
3. Click New.
4. Enter a Name for the pr
oject. You may not change the name after the project is created.
Enter Task name
Select split-screen layout
Select display window
Drag camera from
Device List
Select Main Stream
or Extra Stream
Click Add