Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
47
3. Check Search.
Select alarm type
Check Search
Select NVR and channel
Enter start and end time
Click Search
4. Under Device, select the NVR you would like to search.
5. Under Start
Time and End Time, enter the start and end times for your search.
6. Click Search.
A list of relevant alarms appears below.
Using Playback Mode
You can view recorded footage from your NVR’s in the CMS software.
To use playback mode:
1. Click Playback (
).
2. Under Devic
e, select the NVR and channel you would like to search.
Select NVR
Select Channel
Select search
parameters
Click Search
• Check Multiple channel to playback video from multiple cameras. Select camera and then
click Add. Repeat to add additional cameras.
3. Under Para
meter, select the start and end time for the search.
4. Click Search.