Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
21
Using the Main Menu
Info
The Info menu contains the
following sub-menus showing
system information.
HDD Info
The HDD Info sub-menu shows information
related to the hard drives installed in the
system, including capacity, status, and type.
Click View recording time to see the start and
end times of recordings saved on the hard
drives.
BPS
The BPS sub-menu shows the bitrates of
connected IP cameras.
Log
The Log sub-menu allows you to search for
system logs.
To search for system logs:
1. Under Ty
pe, select the log type to search
for.
2. Under St
art Time and End Time, select the
start and end time for your search.
3. Click Sear
ch.
4. (Optional) Click Ba
ckup to export logs to a
USB flash drive connected to the system.
Version
The Version sub-menu allows you to view
information about the current firmware. You
may also update the firmware through the
version menu.
Updating Firmware
1. Download the latest firmware update from
www.digimerge.com.