Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
16
BACKUP
Backup video files to external USB flash drive (not included) or self-powered USB external hard
drive (not included).
Formatting the USB Device
It is recommended to format your USB device before using it with the system.
Formatting the USB device will permanently erase all data.
To format a USB device:
1. Insert a USB flash drive (not included) or USB ex
ternal hard drive (not included) into one of
the USB ports.
2. From live view, right-click and then select Main Menu. Login if pr
ompted.
3. Click Backup.
4. Check the USB device you would like to format and click Erase. Click OK t
o confirm.
Check the USB device
Click Erase
Backing up Video
1. Insert a USB flash drive (not included) or USB external hard drive (not included) into one of
the USB ports.
2. From live view, right-click and then select Main Menu. Login if pr
ompted.
3. Click Backup.
4. Check the USB device where you would like to save video.