Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
13
RECORDING
By default, the system is set to immediately record at startup from connected cameras. This is
called Continuous Recording. It is highly recommended to keep Continuous Recording on at all
times.
The system supports the fo
llowing recording types:
• Contin
uous Recording: By default, all camera channels are enabled with Continuous
Recording. During Continuous Recording, the Record icon ( ) appears in the channel.
• Motion Recording: Cameras can be configured to record and mark events when motion is
detected. When motion is detected, the Motion icon ( ) appears in the channel.
NOTE: Y
ou must enable motion recording in the Schedule before the system will record motion
events. For details, see “Schedule” on page 24.
• Alarm Recording: Cameras can be configured to record when external alarm devices are
triggered.