Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
12
Setting the Time
SETTING THE TIME
To set the date and time:
1. In the main viewing mode, right-click and click Main Menu. Log into the sys
tem using the
admin account (default User Name is admin and Password is 000000).
2. Click Setting>Gener
a
l.
3. Enter the current date (MM DD YYYY) and time (HH MM SS) under Sys
tem Time.
Set the date and time
Click Save
4. Click Save.
NOTE: To configure Daylight Savings Time see “Gener
al” on page 23. To configure NTP, see
“Configuring NTP” on page 26.
It is highly recommended to set the time on the system prior to doing any
recording.