Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
7
Using the System
USING THE SYSTEM
Password
By default, the login password is enabled. The default system password is 000000.
On-Screen Display
The system shows the following for all display views:
1
3
2
1. Display Area:
• Double-click on a channel to view in full-screen; double-click again t
o return to split screen.
• Right-click to open the Quick Menu. See “Using the Quick Menu” on page 8.
• Left-click to open the Navigation Bar.
• Move the mouse to the top of a channel to view the Camera Toolbar.
• Click-and-drag cameras to rearrange the channel display. This does not affect the channels
each camera is connected or recording to.
2. Channel Name
3. Channel Status
Ic
ons:
• : Channel is recording.
• : Motion has been detected.
• : Camera is locked (covert mode is activated).
The default system password is 000000