Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
107
Appendix F: Hard Drive Installation
Formatting the Hard Drive
After installing a new hard drive, you must format it before the system can recognize it.
ATTENTION: Formatting the HDD erases
all data
on the hard disk.
This step
cannot be undone
. System settings will not be erased.
To format a hard drive:
1. From Live View, right-click and select Main Menu>Adva
nced>HDD Management.
2. Under HDD No
., select the hard drive you would like to format. Information about the hard
drive appears in the lower section of the menu.
3. Under Se
t to, select Format.
4. Click Apply. Click OK
to confirm. Wait for the hard drive to format. Hard drives become Read/
Write hard drives by default when formatted.
Select HDD
Select Format
Click Execute