Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
105
Appendix F: Hard Drive Installation
5. Turn the unit over and tighten the hard drive screws.
6. Turn the unit back over and connect the SATA power and data cables to the hard drive.
7. Replace the cover and cover screws. Make sure to slide the lip on the cover under the bottom
of the front panel.
NOTE: Aft
er installation, you must format the hard drive in order to use it with the system. See
“F
ormatting the Hard Drive” on page 107.
Removing the Hard Drive
To remove the hard drive:
1. Power off the system, and unplug all wiring / cabling from the system.
2. Remove the screws (4x) from the back panel. Slide the cover back and up to remove.
Make sure that the system is OFF and ALL power adapters have been
disconnected before removing/installing the hard drive.