Instruction manual
Table Of Contents
- Getting Started
- Basic Setup
- Front Panel
- Rear Panel
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the Local Area Network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
92
Appendix C: Auto Port Forwarding Wizard
5. Click the Next button and then click Finish to complete the software installation.
Finish button
6. Double-click the Auto Port Forwarding shortcut ( ) from your desktop to start the
program.
Obtaining Your Router Model Number and Version
On most routers, the model and version number can be found underneath the router, printed on
a sticker.
• WGR614 refers to the model number
• v9 refers to the version number
Example
Configuration
You must have the following before you configure the software:
1. Your router’s model number and version number
2. Your router’s user name and password
3. Your device’s IP address
4. Your device’s port numbers that require port forwarding