DH200+ FAQ
Table Of Contents
- Frequently Asked Questions: DH200+ Series
- 1. Press the MENU button on the front panel, remote control, or virtual remote to open the main menu.
- 2. From the main menu, click RECORD ().
- 3. Configure the following for the channel you wish to enable motion:
- 4. Click to save your settings.
- 1. From the main menu, click CAMERA ().
- 2. From the camera section tab, click on the camera that has motion enabled.
- Select camera
- Select all
- "RATE" is set to 15 F/S. This means the system will record at 15 FPS during continuous recording.
- Motion is set to ON. This means the system will start motion recording when the system detects motion.
- Enter the desired recording frame rate during Motion recording
- 3. Click to save your settings
- NOTE: If you change your default port number a different port, you still need to enter your port number after the DDNS address.
- 1. In Internet Explorer, enter your DVR’s DDNS address, followed by /webserver
- 2. Enter the DVR’s user name and password and then click OK.
- 3. Click on the ActiveX toolbar, and click Install ActiveXControl.
- 4. At the Security Warning prompt, click Install.
- 5. Click Next to install the Web Server software. Click Close to complete the installation.
- Up arrow
5
Frequently Asked Questions: DH200
+
Series
Final Results
• The system records continuously with the assigned parameters. In this example, the system
will record at 15 FPS during continuous recording.
• When the system detects motion, Motion recording begins. In this example, the system will
record at 30 FPS when motion is detected (Motion Recording).
• When the post-alarm recording ends, Motion recording stops, and continuous recording
resumes at 15 FPS.
How do I access the DVR using a DDNS address?
After you have port forwarded the required port, created a DDNS account, and enabled DDNS on
your system, you must enter the DDNS URL into Internet Explorer to access your DVR.
The DDNS URL must include http:// , the name of your DDNS URL, followed by a colon, then the
port number of your DVR.
NOTE: If you change your default port number a different port, you still need to enter your port
number after the DDNS address.
For example:
http://tomsmith.digimerge.net:80
URL name
DVR port number