DH200+ FAQ
Table Of Contents
- Frequently Asked Questions: DH200+ Series
- 1. Press the MENU button on the front panel, remote control, or virtual remote to open the main menu.
- 2. From the main menu, click RECORD ().
- 3. Configure the following for the channel you wish to enable motion:
- 4. Click to save your settings.
- 1. From the main menu, click CAMERA ().
- 2. From the camera section tab, click on the camera that has motion enabled.
- Select camera
- Select all
- "RATE" is set to 15 F/S. This means the system will record at 15 FPS during continuous recording.
- Motion is set to ON. This means the system will start motion recording when the system detects motion.
- Enter the desired recording frame rate during Motion recording
- 3. Click to save your settings
- NOTE: If you change your default port number a different port, you still need to enter your port number after the DDNS address.
- 1. In Internet Explorer, enter your DVR’s DDNS address, followed by /webserver
- 2. Enter the DVR’s user name and password and then click OK.
- 3. Click on the ActiveX toolbar, and click Install ActiveXControl.
- 4. At the Security Warning prompt, click Install.
- 5. Click Next to install the Web Server software. Click Close to complete the installation.
- Up arrow
4
Frequently Asked Questions: DH200
+
Series
Enabling Continuous and Motion recording (C+M)
In Continuous and Motion recording mode, the system records 24 hours a day. But as soon as a
camera detects motion, the system records in Motion recording mode. This allows the system to
record at higher frame rates during motion recording, and mark the video as an "event".
Step 1 of 2: Enable Continuous and Motion recording
1. From the RECORD menu configure the following:
• RATE (Continuous): Select the continuous recording frame rate (i.e. 15 F/S)
• MOTION: Select ON.
• QUALITY: Select the desired video quality during Motion and Alarm recording.
• ALARM: Turn ON/OFF to enable/disable Alarm recording.
• ALARM: Select ON if you wish to enable Alarm recording.
2. Click to save your settings.
Step 2 of 2 : Configure Motion Recording frame rates
1. From the Main Menu, click EVENT ( ).
2. Configure the following beside the channel that has motion enabled:
• MOTION: Select the frame rate the system will record at when it detects motion (i.e 30F/S)
• Select the recording quality (LOW, MIDDLE, SUPER, HIGH, ULTRA)
3. Click to save your settings
"RATE" is set to 15 F/S.
This means the system
will record at 15 FPS
during continuous
recording.
Motion is set to ON. This
means the system will
start motion recording
when the system detects
motion.
Enter the desired
recording frame rate
during Motion
recording
Enter the image
quality during
Motion recording