Instruction Manual

EN
ALARM CLOCK SETTINGS
 Briefly press the MODE button in the time display. 12:00 (default) or the last set alarm time
will be displayed.
 Hold the MODE button to enter the setting mode.
 The alarm icon will appear on the display and the minutes will flash, press the UP button to
set them.
 Confirm by pressing the MODE button and the hour starts flashing, set it with the UP
button.
 Press MODE to confirm the setting. The wake-up time and the alarm symbol are shown on
the display. The alarm clock is activated.
 Press MODE to return to the time display.
 When the alarm clock rings, press any button to stop it. If you do not press any button, the
alarm will stop after one minute. The wake-up time will remain active.
ACTIVATION/DEACTIVATION OF THE ALARM AND CLOCK SIGNAL
 Press the MODE button in the time display and the set alarm time will be displayed instead
of the current time.
 Press the UP button once to activate the set alarm clock. The alarm clock symbol (bell) will
appear on the display.
 Press the UP button again to activate the clock signal. The corresponding symbol appears on
the display.
 The third press of the UP button activates both functions. Both symbols are shown on the
display.
 The fourth press of the UP button deactivates both functions. The symbols disappear.
 Press the MODE button to return to normal mode.
DATE DISPLAY
 By pressing the UP button when the current time is displayed, the date will be briefly
displayed instead of the time.
PLACEMENT AND ATTACHMENT
 The device can be placed on a mat using the folding stand or you can hang it on the wall
using the hole on the back of the device.
CARE AND MAINTENANCE
 Clean the device with a soft damp cloth. Do not use cleaning agents.
 Remove the battery if you are not going to use the device for a long time.
 Store the device in a dry place.
BATTERY REPLACEMENT
 Replace the battery when the display starts to dim.
 Open the battery compartment, remove the old one and insert a new AAA battery with the
correct polarity.
 Close the battery compartment.
PROBLEM SOLVING
No data is shown on the display: Incorrect data on the display:
 Make sure the battery is installed correctly
 Replace the battery
 Replace the battery
Page 3 / 4