Instruction Manual

EN
B: Back side
B1: Hanging hole
B2: MODE button
B3: UP button
B4: MAX/MIN button
B5: °C/°F button
B6: Battery compartment
B7: Flip-out stand
B8: Battery compartment cover
GETTING STARTED
 Open the battery compartment and insert one new AAA alkaline battery.
 Close the battery compartment again.
 All segments of the display will be displayed for a short time.
 The device is ready for use.
 The temperature and humidity will be shown on the display.
MODE SELECTION
 In normal display mode, you can use the MODE button to select between time display
modes and alarm mode.
 When the time mode is displayed, the colon separating the hours and minutes will flash, in
the alarm mode, the colon will be permanently displayed on the display.
MAX/MIN VALUES
 Pressing the MAX/MIN button displays the maximum measured values since the last reset.
 Press the MAX/MIN button again to display the minimum measured values since the last
reset.
 By pressing the MAX/MIN button again, the display switches to displaying the current
temperature and humidity values.
 If you want to reset the minimum and maximum values, then it is necessary to hold the
MAX/MIN button for 2-3 seconds.
TEMPERATURE UNIT SETTING
 Press the °C/°F button to set the temperature unit (Celsius or Fahrenheit).
SETTING THE CLOCK AND CALENDAR
 Press and hold the MODE button.
 The minutes are flashing, you can set them with the UP button.
 With each further short press of the MODE button, the hour, time display format (12/24
hour), year, month and day will gradually flash, which you can gradually set to the desired
value with the UP button.
 Press the MODE button for the last time to confirm everything and the time will appear on
the display.
Page 2 / 4