Owner's manual

Digilent D2XL Reference Manual Digilent, Inc.
www.digilentinc.com page 6 of 7
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
Expansion connectors
The two expansion connectors labeled E and F on the D2XL
board use 100 mil spaced DIP headers. Both connectors
have GND routed to pin 1, VU routed to pin 2, and 3.3V
routed to pin 3. Pins 4-40 for both connectors route directly to
individual FPGA pins. The connectors are separated by 400
mils, so any D2-family peripheral board can be placed used
with the D2XL board.
The TQ144 package used on the D2XL board has 77 signal
pins available to the user (the remaining I/O signals are
routed to the parallel connector and other on board devices).
Of these, 37 are routed to the E connector, 37 to the F
connector, and 3 are left unconnected. Data rates of up to
100MHz are attainable across the E and F connectors.
D2XL Expansion Connector pinouts
E connector F connector
Pin Signal S-II pin Pin Signal S-II pin
1 GND - 1 GND -
2 VU - 2 VU -
3 VDD33 - 3 VDD33 -
4 A4 122 4 B4 56
5 A5 121 5 B5 54
6 A6 120 6 B6 51
7 A7 118 7 B7 50
8 A8 117 8 B8 49
9 A9 115 9 B9 48
10 A10 114 10 B10 47
11 A11 113 11 B11 46
12 A12 112 12 B12 44
13 A13 103 13 B13 43
14 A14 102 14 B14 41
15 A15 100 15 B15 40
16 A16 99 16 B16 31
17 A17 96 17 B17 30
18 A18 95 18 B18 29
19 A19 94 19 B19 28
20 A20 93 20 B20 27
21 A21 87 21 B21 26
22 A22 86 22 B22 23
23 A23 85 23 B23 22
24 A24 84 24 B24 21
25 A25 83 25 B25 20
26 A26 80 26 B26 19
27 A27 79 27 B27 13
28 A28 78 28 B28 12
29 A29 77 29 B29 11
30 A30 75 30 B30 10
31 A31 74 31 B31 7
32 A32 67 32 B32 6
33 A33 66 33 B33 5
34 A34 65 34 B34 4
35 A35 63 35 B35 3
36 A36 62 36 B36 76
37 A37 60 37 B37 64
38 A38 59 38 B38 42
39 A39 58 39 B39 88
40 A40 57 40 B40 18
Pin 1: GND
Pin 2: VU
Pin 3: 3.3V
Pin 39
Pin 40
Pin 4
Pin 39
Pin 40
F connector E connector
37
DB-25
Spartan
2XCS30
TQ144
37
F E
E bus F bus
D2XL expansion connector signals