MCC USB-230 Series: USB-234 16-bit, 100 kS/s Multifunction DAQ Device - User Guide

USB-234 User's Guide Installing the USB-234
9
1
Screw terminal connector plugs
2
Hi-Speed Micro -USB cable
Figure 2. Setting up a USB-234
When connected for the first time, a Found New Hardware dialog box opens when the operating system detects
the device. When the dialog closes, the installation is complete. The LED turns on after the device is
successfully installed.
If the LED turns off or blinks
If the LED turns off, the device is either not fully connected or is in suspend mode.
If the LED blinks, the device has encountered an error. Wait 10 seconds to allow the device to attempt to
recover from the error. If the LED continues blinking, disconnect and reconnect the device. Contact
Measurement Computing if the error persists.
Calibrating the hardware
The Measurement Computing Manufacturing Test department performs the initial factory calibration. Return
the device to Measurement Computing Corporation when calibration is required. The recommended calibration
interval is one year.