Instruction Manual

XUP Virtex-II Pro Development System www.xilinx.com 75
UG069 (v1.0) March 8, 2005 1-800-255-7778
R
Right click on each of the devices in the chain and select “Assign New Configuration File”
from the drop-down menu (see Figure A-6). The Platform FLASH PROM and the System
ACE controller should be set to BYPASS, and the desired configuration file for the FPGA
should be specified as shown in Figure A-7.
Figure A-5: Properly Identified JTAG Configuration Chain
Figure A-6: Assigning Configuration Files to Devices in the JTAG Chain