Instruction Manual

22 www.xilinx.com XUP Virtex-II Pro Development System
UG069 (v1.0) March 8, 2005
Chapter 2: Using the System
R
Figure 2-3 illustrates the configuration data path.
Four status LEDs show the configuration state of the XUP Virtex-II Pro Development
System at all times. The user can see the configuration source, configuration version, and
tell when the configuration has completed from the status LEDs shown in Table 2-1.
Figure 2-3: Configuration Data Path
Micro PortJTAG Port
USB2
Microcontroller
& CPLD
JTAG Port
PROM
JTAG
SMAP Port
USER
GOLDEN
SMAP Port
PLATFORM
FLASH
JTAG Port
FPGA
SystemACE
Controller
Test JTAG Port Config JTAG Port
Micro Port
VERSION SELECT
CONFIG SOURCE
CF CONFIG SELECT
UG069_06_122704
CF Card/
MicroDrive
Table 2-1: System Configuration Status LEDs
System Status
LED Status
D19 (Green)
PROM Config
D20 (Green)
CF Config
D14 (Amber)
GOLDEN Config
D4 (Red)
Done
SelectMAP USER LOADING ON OFF OFF OFF
SelectMAP USER COMPLETED ON OFF OFF ON
SelectMAP GOLDEN LOADING ON OFF ON OFF
SelectMAP GOLDEN
COMPLETED
ON OFF ON ON
JTAG COMPACT FLASH
LOADING
OFF ON OFF OFF
JTAG COMPACT FLASH
COMPLETED
OFF ON OFF ON