Instruction Manual

104 www.xilinx.com XUP Virtex-II Pro Development System
1-800-255-7778 UG069 (v1.0) March 8, 2005
Appendix D: Using the Golden FPGA Configuration for System Self-Test
R
6. The user is prompted to select which loop to test (Figure D-5).
7. After entering “1” from the “Main Menu” in the terminal window, select which of the
two serial ATA pairs you would like to run the test on. See Figure D-6.
8. After selecting one of the two tests, the screen will clear, and the reset /link status is
displayed as shown in Figure D-7.
This indicates that the MGTs were correctly reset and that at least one of the two serial
ATA transceivers is able to establish “link up” status. The screen will also clear and the
second test status menu will be displayed.
Note:
The link status line is highlighted, showing that both transceivers have bidirectional
communications links established and are transmitting and receiving data.
Figure D-5: Selecting the SATA Port Tests
Figure D-6: Selecting the Specific SATA Port to Test
Figure D-7: Resetting the MGTs