Datasheet

was just cloned, prior to running the following command (if using the Vivado TCL Console
instead of Python):
set argv ""; source digilent-vivado-scripts/digilent-vivado-checkout.tcl
2. Download and extract the demo files, linked in the Downloads section, above.
3. After recreating the project in Vivado, generate the bitstream file.
4. Make sure the boot mode jumper on the Eclypse Z7 is on the JTAG position.
5. Open Hardware Manager tool from within Vivado and click Open target, Autoconnect:
6. Select the .bit file, or make sure it is already selected and is located at the correct path in the dialog,
and program the board.
7. Open WaveForms, then open the workspace, “EclypseZ7VhdlFilterDemo.dwf3work”, included in the
folder extracted from the demo archive.
Hit the Run button of the Network Analyzer instrument.