User manual

Zybo Z7 Board Reference Manual
Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Page 28 of 31
Pin Number
Function
Zybo Z7 Connection Details
1
GND
GND
2
MIPI CSI-2 Lane 0 (-)
Terminated and connected to 2 FPGA pins as described in
XAPP894
3
MIPI CSI-2 Lane 0 (+)
Terminated and connected to 2 FPGA pins as described in
XAPP894
4
GND
GND
5
MIPI CSI-2 Lane 1 (-)
Terminated and connected to 2 FPGA pins as described in
XAPP894
6
MIPI CSI-2 Lane 1 (+)
Terminated and connected to 2 FPGA pins as described in
XAPP894
7
GND
GND
8
MIPI CSI-2 Clock (-)
Terminated and connected to 2 FPGA pins as described in
XAPP894
9
MIPI CSI-2 Clock (+)
Terminated and connected to 2 FPGA pins as described in
XAPP894
10
GND
GND
11
GPIO
Direct Connection to FPGA
12
GPIO
Direct Connection to FPGA
13
SCL
Direct Connection to FPGA, with 1.5 KOhm Pull-up
14
SDA
Direct Connection to FPGA, with 1.5 KOhm Pull-up
15
3V3
3.3 V Power rail
Table 15.1. Pcam Pin-out.
Pcam modules are connected to the Pcam host port using a flexible flat cable (FFC). To connect the cable to the
Zybo Z7 follow these instruction (Fig. 15.2 depicts each step):
1. Locate the Pcam connector between the two HDMI ports.
2. Pull directly up on the off-white colored tab to open the connector.
3. Insert the FFC with the contacts facing the top edge, away from the center of the Zybo Z7.
4. Ensure the FFC is fully inserted.
5. Gently press down on both sides of the off-white colored tab to latch the FFC into the connector.
6. The FFC is now connected properly.
Figure 15.2. Attaching a Pcam.