Owner's manual

MRK Reference Manual
www.digilentinc.com page 5 of 8
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
7. Get the two wheels and the rubber traction bands. Stretch the rubber band around the outside
of the wheel. Attach the wheels to the motors.
8. Compare your Cerebot MX4cK board to the picture below. Note that the blue shorts are
attached to each jumper as shown. Remove the rubber feet from the bottom of the corners of
the Cerebot MX4cK. Attach the standoffs to the board using the mounting screws. Mount the
Cerebot MX4cK board to the top side of the platform. Be careful not to cross thread the
screws while mounting the Cerebot MX4cK board.