Operating instructions

5 - 17
MAN0443.P65 Issue 13 Aug 04 5701 Control System
05701-M-5001 A02279
CHAPTER 5 - COMMISSIONING AND
MAINTENANCE INSTRUCTIONS
72 Calibration Gas Too High
The calibration gas too high message is
displayed during calibration when the
calibration gas is adjusted to a level above
the pre-configured level.
This would not be indicated under normal
local operation since the pre-configured
operational data of the Engineering Card
push-buttons will prevent this type of
adjustment.
All Active No No
5.5 System Errors
69 Invalid Sub-Channel
Indicates a request has been received for
an invalid sub-channel address.
68 Printer Not Ready
Indicates that the serial device attached to
the engineering port is not able to accept
data.
67 Invalid Request
Indicates that an invalid request number
has been received.
66 Serial Communications Timeout
Serial communications has timed out.
Reset card by removing power to the card.
If problem persists, replace the card.
65 Failed Error
Failed to receive command or card selected.
Reset card by removing power to the card.
If problem persists, replace the card.
All Active No No
All Active No No
All Active No No
All Active No No
All Active No No
Error Error Code Meaning S/W Card Fault Latch
Code Status Signal
Error Error Code Meaning S/W Card Fault Latch
Code Status Signal