Troubleshooting guide

29
Appendix C: SoundGrid-Compatible Switches
Since Waves SoundGrid is an Ethernet-based protocol, it requires a network switch to connect
all its components. For proper functioning, you will need to use a gigabit switch that supports
jumbo frames.
The following switches have been tested and certified for use with SoundGrid systems:
• Prosafe Gs108v3 8-port gigabit switch
• HP 1410-16G s (J9560A) 16-port rack-mountable switch
• Switch
Led State Per Port
Activity
ProSafe 8-Port Gigabit Ethernet Switch
GS108v3
Left LED – 100 Mbps link
Right LED – 10 Mbps link
Both LEDs – 1000 Mbps link
Blinking
HP 1410-16G (J9560A) 16-Port Rack
Mountable Switch
Link/Act – 10 or 100 Mbps
Speed ON – 1000 Mbps
Blinking
Switch
Led State Per Port
Activity
ProSafe 8-Port Gigabit Ethernet Switch
GS108v3
Left LED – 100 Mbps link
Right LED – 10 Mbps link
Both LEDs – 1000 Mbps link
Blinking
HP 1410-16G (J9560A) 16-Port Rack
Mountable Switch
Link/Act – 10 or 100 Mbps
Speed ON – 1000 Mbps
Blinking
Switch
Led State Per Port
Activity
ProSafe 8-Port Gigabit Ethernet Switch
GS108v3
Left LED – 100 Mbps link
Right LED – 10 Mbps link
Both LEDs – 1000 Mbps link
Blinking
HP 1410-16G (J9560A) 16-Port Rack
Mountable Switch
Link/Act – 10 or 100 Mbps
Speed ON – 1000 Mbps
Blinking