Specifications

44
DIGIGRID DLS/DLI
4.3 Basic SGP Configuration
Incorporating a DigiLink-compatible I/O into a SoundGrid network involves three processes:
■
Connecting hardware
■
Conguring devices in SoundGrid Studio Device Racks
■
Congure attched DL device from DLS control panel
■
Patching between devices and ASIO/Core Audio drivers in the SoundGrid Studio Patch page
4.3.1 Connecting One DigiLink-Compatible I/O Device in SGP Mode
■
Power up the DLI/DLS and DigiLink-compatible I/O.
■
Connect the host computer to the DLS Ethernet port.
■
Connect DLS Port 1 to the DigiLink I/O device’s primary port.
■
Set both switches on the rear panel of the DLI/DLS to “SGP.”
■
Connect Loop Sync between DL devices as you would with Pro Tools.
Power up the devices. LEDs on the DLI/DLS front panel will conrm network status and indicate that the device is in SGP mode. If
the network light is not illuminated, use SoundGrid Studio to diagnose the problem. If the front panel indicates “I/O,” this means you
probably didn’t set the rear panel switches correctly.
Mode Swiches - Back Panel
Mode indicator - Front Panel