Specifications

32
DIGIGRID DLS/DLI
a. Establishing Clock between DigiLink-Compatible I/Os and DLI/DLS
1
DigiLink-compatible I/O devices (including DLI/DLS) are controlled from the Pro Tools
Hardware Setup page. Use the Clock Source menu to set the clock of the attached
I/O devices. In this example, the device attached to the Pro Tools Core card is called
“192 I/O #1.” The DLS device is listed below as “192 Digital I/O #1.” Congure it as you
would any other Pro Tools peripheral.
These devices are now locked to each other: one Loop Sync master
(192 I/O) and Loop Sync slave (DLS, appearing to Pro Tools as “192
Digital I/O #1”). You can verify clock settings in the DLS control
panel. In this example, the DLS is locked to the 192 via Loop Sync
and its status is “OK.”
1. For maximum exibility, we recommend that you install Loop Sync cables in “both directions.” While some congurations will function with only one Loop
Sync cable, a complete loop enables you to switch easily from one conguration to another.