User Manual
14
DigiGrid M
The new device is visible in the rack slot. Unless changed by the user, it remains a clock slave and
is colored green. Use the same menu to change the clock master assignment from one device to
another or to remove the device from the rack slot.
4.1 Device Firmware
Firmware is a small program that runs on a device in order to control it. It enables DiGiGrid M to communicate correctly with
SoundGrid Studio. An I/O that is using outdated or incompatible rmware will not work properly in a SoundGrid network until its
rmware is updated. To see if your DiGiGrid M rmware is compatible with the version of SoundGrid Studio that you are currently
running, go the System Inventory page and locate the device. Next to each device slot is a button labeled FW, whose color indicates
rmware status.
Grey Compatible rmware
Blue Compatible rmware, but a newer version exists
Red Firmware not compatible and must be updated in order to use
Click on the FW button to launch the rmware Updater. This will initiate a scan of the hardware and then oer options.
Do not disconnect the device or turn o the computer until you see “Done.” After updating, turn the DiGiGrid M OFF and
back ON to reset the device.