User Manual

Adjusting the gains on the analog outputs and displaying vu-meters
Click on the icon to set the parameters for audio outputs.
For each output, the volume slider allows adjusting the analog
attenuation, 0dB to - 72 dB, by 1 dB steps.
It is possible to adjust the volume of several outputs at the same
time, by moving only one slider. To do so, press “Shift + Click”
on each slider. The cursor of the slider becomes purple. When
all the selected sliders are purple, just move one of them. All the
sliders move at the same time.
Output alignment is as follows:
Slider set to 0 dB: 0 dBfs -> +10dBu
Slider set to -72 dB: 0 dBfs -> -62dBu
The vu-meters display the signal level before the digital to analog
conversion. The peak-meter instantaneous value is displayed
right above the vu-meter.
To mute an output, click on the corresponding Mute icon .
Mute is ON when icon is red .
Displaying the signal level on the AES/EBU output(s)
Click on the icon , on the bottom right of the “ANALOG”
window, to view the digital level on the outputs signals. A vu-
meter is displayed for each input channel, which gives the digital
level of the signal on the digital output, expressed in dBfs (0dBfs
is the maximum value of a digital sample).
To hide the digital levels panel, click on the icon .
16