User Manual

PCX924HR & PCX924HR-Mic, PCX22HR
User’s Manual
9
HARDWARE REQUIREMENTS
Minimum requirements
• Pentium III 700 MHz (or equivalent) minimum
• One free PCI (3.3 V or 5 V keyed) or PCI-X slot
Software requirements
SOFTWARE REQUIREMENTS To use your PCX924HR or PCX924HR-Mic,
install the driver from the np Runtime HR package version 1.40 or higher.
This package includes a
WDM DirectSound driver. Microsoft DirectX 9 or a
later version must also be installed. The card can also be used with
applications based on Digigram‘s np SDK
Supported operating systems
PCX924HR and PCX924HR-Mic cards run under Windows 2000, Windows
XP
1
, and Windows 2003 Server
1
, are compatible np SDK, and come along
with low-latency DirectSound, Wave, and ASIO drivers.
HARDWARE INSTALLATION
The card has to be installed in the computer prior to installing its driver.
Installing the card
Gently plug the card in a free PCI slot and press it down to position it firmly.
Tighten the screw.
Interrupt and memory address
Hardware interrupt and addresses are automatically set up at start-up by the
PCI PnP BIOS.
SOFTWARE INSTALLATION
Please visit the Digigram web site at www.digigram.com for the most recent
driver.
In case you run a specific application developed or installed by a Digigram
partner, it might require the use of a specific driver version. In this case, make
sure that the updated driver has been approved by your supplier.
1
3- bit version