User Manual

D i g i g r a m
8
PCX924HR, PCX924-Mic, and PCX22HR
Main software features
• Decoding and mixing of several PCM (8, 16 and 24 bits) and MPEG
Audio streams (Layer 1, II & III, up to 48 kHz sampling frequency)
• Real-time, simultaneous record and playback in PCM (8, 16 and 24 bits),
Float IEEE754 conversion (with 24-bit fixed-point dynamic range), as
well as in MPEG Audio Layer I, Layer II, and Layer III
L
• When using the np SDK, direct monitoring, level adjustment, panning,
cross-fades, punch-in/punch-out, scrubbing, time-scaling, inter-board
synchronization, synchronization on LTC (SMPTE)
• Possibility to control the parameters of the inputs and outputs (gains,
mutes, 48 V switch, analog compressor-limiter-expander parameters),
from the provided ‘Digigram Hardware Settings’ application, or from any
application that addresses these controls
• 24-bit DSP effects in playback and recording: 3-band parametric
equalizer plus Maximizer
• Low latency DirectSound, Wave, and ASIO drivers
L
MPEG Layer III play-only on DSP;
MPEG Layer III recording on the host computer is available through Digigram's PC
Codec using the np SDK