User Manual

PCX924HR & PCX924HR-Mic, PCX22HR
User’s Manual
11
How to check the installation
Once the driver and the cards are installed according to the procedure
described in this manual, you can verify that the card is properly installed and
works fine as follows:
• Menu <Start> <Settings> <Control panel>, <Sound and Multimedia>,
tab “Audio”, Default device (Playback device, Recording device). The
card’s channels can be selected. the card can be used with any
DirectSound application (see pages hereafter).
• The card is also visible via the np interface: Go to <Start>
<Programs> <Digigram> and select <Digigram Control Center>.
• In the “Digigram drivers” window, select the ‘General
Information’ tab.
In the “Modules Information” window, you can see the HR
Runtime modules that have been installed, and their versions.
• In the “Digigram drivers” window, select the ‘Diagnostics’ tab.
You should see here the icons of the cards you have installed.
If the card you have installed is listed:
• Right click on the icon of the card.
• Select Diagnostics, and Play Sine. This plays in loop a sine signal
on the outputs of the card. You can also select Play file to play in
loop a file of your choice (PCM or MPEG).
If the playback is correct, the card is correctly installed and
works.
• To stop the playback, right click on the card icon, and select Stop
Activities.
The card is also visible via the DHS control panel (cf. dedicated
chapter next page).
If the card is not displayed:
• Make sure that during the HR runtime installation the “Driver
for the HR boards” has been selected in the “Select components”
window.
• make sure that the card is correctly inserted in the PCI slot, and
screwed on the PC chassis.
• if necessary, uninstall HR runtime package as described in this
manual, and re-install it.