Specifications

Trillium Lane Labs Plug-ins Guide18
TL AutoPan Controls
The TL AutoPan interface is divided into several
sections, each of which is described below.
Output Meters
The Output meters display the amplitude of the
outgoing audio. In mono-to-stereo mode, a two
meter bar is shown. In mono-to-LCR, quad, or
5.0 mode, three, four, or five channels are
shown respectively.
The Clip indicator lights red when the channel
has clipped. The clip indicator for each channel
can be cleared by clicking it.
Panner Section
The Panner section provides different controls
for different output channel configurations.
TL AutoPan in mono-to-stereo and mono-to-
LCR formats provide controls common to all
output configurations: Output, Width, and
Manual. TL AutoPan mono-to-quad and mono-
to-5.0 formats provide additional controls de-
pending on the Path selection: Angle and Place,
or Spread. Additionally, the Panning Source se-
lector, Panning display, and Path selectors are
common to all output channel configurations.
Output
The Output slider lets you cut or boost the out-
put signal level from –24 dB to +12 dB.
Width
The Width slider controls the width of the pan-
ning field. At 100%, the panning field is at its
widest. At 0%, the panning field is centered and
stationary. The Width slider effectively deter-
mines the amount of LFO or Envelope control
on the pan position.
Manual
The Manual slider directly controls the pan po-
sition, this lets you manually control the pan
position from a control surface or by using auto-
mation. The amount of manual control is af-
fected by the setting of the Width slider. For full
manual control, set the Width slider to 0%.
When the Width slider is at 100%, the Manual
slider has no effect on the pan position. When
Width is set to 50%, the LFO sweeps the posi-
tion through 50% of its range and the Manual
slider lets you move the position of that 50%
range.
Output meters (L, C, R, Ls, Rs)
Panner section, mono-to-stereo, left to right path
selected