Specifications
Chapter 11: TL Space TDM and TL Space Native 103
Reverb
The Reverb group offers a low and high shelf EQ
in addition to width and balance controls. The
EQ operates prior to convolution processing.
Lo Freq Adjusts the frequency of a low frequency
filter from 20 to 500 Hz.
Lo Gain Cuts or boosts the frequency set in Lo
Freq from –15 dB to +15 dB.
Hi Freq Adjusts the frequency of a high fre-
quency filter from 500 Hz to 20 kHz.
Hi Gain Cuts or boosts the frequency set in Hi
Freq from –15 dB to +15 dB.
Width Increase or reduces the stereo spacious-
ness of the reverb. Use this control to tailor the
reverb’s character in a mix. Keep in mind that
an IR that has little stereo separation to begin
with may have limited results.
Balance Controls the balance of the reverb out-
put. Use this control to balance a reverb from an
IR that has been captured without a centered
stereo image, or for creatively controlling the
character of the reverb in a mix.
Reverse Reverses the IR waveform and controls
the total length. As the IR waveform is recalcu-
lated, it is re-displayed in the Waveform display.
The value shown is measured in Beats Per
Minute to let you easily match the tempo of the
music.
Decay
The Decay group controls allow the user to con-
trol the decay of the low, mid, and high fre-
quency portions of the IR. Use the controls to
tailor the reverb’s character for a mix or for cre-
ative possibilities not found in traditional reverb
processors.
Low Decreases or increases the rate at which low
frequencies decay.
Low Xover Adjusts the frequency point that di-
vides the IR into low and mid frequency por-
tions.
Mid Decreases or increases the rate at which mid
frequencies decay.
High Xover Adjusts the frequency point that di-
vides the IR into mid and high frequency por-
tions.
High Decreases or increases the rate at which
high frequencies decay.
Front/Rear In quad and 5.0 channel output
modes, Front and Rear independently control
the decay for front and rear channels.
Info Screen
Click the Trillium Lane Labs logo to view the
Info screen. The Info screen displays copyright
and version information.
If the waveform is reversed using the Re-
verse control, effected audio may continue
to play for several seconds after the trans-
port is stopped or audio input finishes.