Specifications

Synchronic Plug-in Guide44
Wait Bar Forces recalled combinations to wait
and start at the beginning of the next bar in-
stead of the next beat or slice.
MIDI Edit Mode
In Edit mode, MIDI Pitch Bend or MIDI contin-
uous controller numbers can be assigned to con-
trol Synchronic’s five User Knobs and the XFade
crossfade fader.
Assigning an External MIDI Controller
Below the five User Knobs and crossfader (XF)
labels are pop-up menus for assigning MIDI con-
trollers.
To assign an external MIDI controller:
1 If necessary, switch the MIDI module to Edit
mode (see “Performance and Edit Modes” on
page 13).
2 Select Pitch Wheel or Controller # from the
Source pop-up menu.
3 If you selected Controller #, you will also need
to enter the MIDI controller number in the
MIDI Control Number field, either by selecting
the field and typing the number or by jiggling
the MIDI controller.
Pitch Wheel Assigns MIDI pitch bend (the pitch
wheel) to control the corresponding User Knob
or the XFade crossfade fader.
Controller # Assigns a continuous MIDI control-
ler to control the corresponding User Knob or
the XFade crossfade fader.
MIDI module, Edit mode
To save a template of your MIDI control as-
signments, configure a default Synchronic
insert (with no sounds loaded) for your
MIDI controller and save it as a Synchronic
plug-in settings file using the Settings Li-
brarian (see Chapter 7, “Synchronic Plug-in
Settings”).
Selecting MIDI control source
MIDI Controller # field assignment for PB2 User Knob
(set to MIDI controller #1, the modulation wheel)
If Controller # is selected in the Source pop-
up menu, and the Controller # field is se-
lected, you can jiggle the MIDI controller to
make the correct controller assignment.