Specifications

Chapter 4: Synchronic Controls 37
Noise Mode
There are three different Noise modes: Dark,
White, and Brite; each with two variations: a
noise generator (Osc) or amplitude modulation
(AM).
Dark Modulates the signal with a low pass fil-
tered form of white noise, using either an oscil-
lator or amplitude modulation (AM).
White Modulates the signal with white noise, us-
ing either an oscillator or amplitude modulation
(AM).
Brite Modulates the signal with a high pass fil-
tered form of white noise, using either an oscil-
lator or amplitude modulation (AM).
Filter Effect
The Filter effect processes the post-Noise signal
using a lowpass filter, a highpass filter, or ring
modulation.
BEG and END Range (0–100%) Use the BEG and
END parameters to determine the range of a fil-
ter frequency sweep when modulated by the
LFO Waveshapes. The actual cutoff frequency in
Hertz varies from between filter types.
LFO1 and LFO2 Set the Waveshape and Duration
for dynamic sweeping filter effects. For static fil-
ter effects, set both LFO1 and LFO2 to Off.
Selecting Noise Mode
Filter effect
LFO Waveshapes and Durations options
are the same as those provided in the Play-
back module. See “Low Frequency Oscilla-
tor (LFO)” on page 33.
Filter Enable
Filter Select
button
LFO Waveshape
selectors
Beginning Filter
amount (%)
End Filter
amount (%)
LFO Duration
selectors
button
Filter Mode