User guide

Soundcraft 328XD and Digidesign Pro Tools
3
33
3
MIDI CONFIGURATION
It is essential that 2 way MIDI communication occurs between the 328XD and Pro Tools.
Using standard MIDI cables, connect the 328XD MIDI Out Port to your MIDI interface’s MIDI In Port, and
connect the 328’s MIDI In Port to the interface’s MIDI Out Port.
This 2 way communication configuration will allow full dynamic automation of the 328XD, and it will allow
control of the internal mixer within Pro Tools from the 328XD.
OMS Setup
Before launching Pro Tools, we must configure OMS to account for the 328XD. This guide will refer to
OMS version 2.3.8.
Launch the OMS Application.
Under “Studio” select New Device
Configure the new device as described below:
Set the Device ID
to 0.
Check “Is controller” and “Is
multitimbral”.
Enable all receive channels
Enable MIDI Timecode
(MTC) and MIDI
Machine Control (MMC)
as indicated.